0000-The attempt at communication with the printer fails at start-up.
0001-There is a DDI-P communication error.
0010-DDI-P communication error DC controller cannot detect Vsync signal even after 2 minutes elapsed from register setting completed in the controller.
there was a firmware update for E733 during fax transmission-in ver.12.04 in y2006
check for short-
Check if the wire harness for the vertical transport sensor PS24 is contacting the vertical transport roller shaft causing the insulation to wear off and the machine to malfunction.
Repair or replace the wire harness.
if fact check all sensor wire harnesses in that area (ex.PS28) also
No comments:
Post a Comment