Canon ir5570 error | manual story

Canon ir5570 error

    E000001-0010=The power has been turned off and then back on without resetting the error.
    - Reset the error. (COPIER>FUNCTION>CLEAR>ERR)

    E000001-0001=There is an error or an open circuit in the main thermistor, shutter thermistor, or sub thermistor.
    - Check the connector of each thermistor or any fault in
    connection and wiring.
    - Replace the thermistor in question.
    - Replace the DC controller PCB.

    E000732-0001=There is a fault in the reader communication./There is a DDI-S communication error.
    - Check the communication between the reader unit and the main controller.
    - Check the power supply of the reader unit. (Check to see if initialization takes place at start-up.)
    - Replace the reader controller PCB,reader relay PCB, or main controller PCB.

    E000733-0001=There is a fault in the printer communication./There is a DDI-P communication error.
    - Check the connection of the cable between the DC controller and the main controller.
    - Check the power supply of the printer. (Check to see if initialization takes place at start-up.)
    - Replace the DC controller PCB or the
    main controller PCB.

    Service Mode
    1) Press the asterisk key (*) on the operation panel.
    2) Press 2 and 8 simultaneously on the numeric keypad.
    3) Press the asterisk key (*)on the operation panel.
    COPIER >FUNCTION>CLEAR>ERR
    Use it to reset an error codes
    1) Select the item, and press the OK key.
    2) Turn off and then on the main power.

    WARNING
    Be careful what u clear/ only use it on error codes if u have no experience on CANON COPIERS